The corrosion fatigue behavior of epoxy-coated Mg-3Al-1Zn alloy in gear oil was investigated. The corrosion and the fracture surfaces after fatigue test were analyzed by scanning electron microscopy(SEM) and the corrosion compositions were measured by energy-dispersive spectrometry(EDS). The fatigue properties and the crack initiation mechanisms of the specimens before and after epoxy coating treatment were discussed. The results indicate that the fatigue limit after epoxy coating treatment in gear oil is higher than that of the uncoated specimens. The epoxy coating is an excellent way to prevent direct contact between the Mg-3Al-1Zn alloy and surrounding environments. The mechanical properties of the epoxy coating layer are lower than that of magnesium alloy, which is the main reason for the fatigue crack initiation on the epoxy coating layer. In addition, the gear oil lubrication could lead to the flaking off of the epoxy-coated layer.
The effect of the rare earth element Er on the microstructures and properties of Mg-Al intermetallic were studied in this experiment. Metallographic and X-ray diffraction（XRD） results showed that the microstructures of Mg-Al-Er alloys varied with Er content. The Mg-44Al-0.5Er and Mg-43.8Al-1.0Er alloys were both composed of Mg17Al12 matrix and Al3 Er phase, whereas Mg-43Al-3.0Er and Mg-42Al-5.0Er were composed of Mg17Al12 matrix, Al3 Er phase, and Mg-Mg17Al12 eutectic. The Mg-42Al-5.0Er alloy showed the highest microhardness, and the values remained nearly stable as Er content increased from 1.0 wt.% to 5.0 wt.%. The dispersed second phase Al3 Er caused the grain refinement of the Mg-Al-Er alloy, which was the main reason for the improvement in microhardness. The corrosion resistance of the Er-containing alloys initially increased and then decreased with increasing Er content. All the Er-containing alloys had the ability to suppress hydrogen evolution, which was the main reason for the higher corrosion resistance of the modified alloys than that of the Mg-44.3Al alloy. Considering the higher hardness and dispersity of the Al3 Er phase, Mg-43.8Al-1.0Er exhibited higher wear resistance than the as-cast Mg-44.3Al alloy.
