In order to study the size effect on the AE rate ’a’ value,three kinds of mix ratios were set up by different particle sizes and water cement ratios,45 cement mortar specimens with five different heights were tested under axial compression.And the whole damage processes were monitored by full-digital acoustic emission acquisition system,followed by an analysis of mechanical behavior and AE activity.The experimental results show that the height of the cement specimen has significant effects on the compressive strength and the acoustic emission rate ’a’ value,but a slight effect on the accumulated AE hits number,which is analyzed from aspects of failure process of cement mortar specimens.
王岩HU HongxiangLU GuijuanCHEN ShijieLIU ShaojunWANG Yao
The fiber reinforced concrete has good dynamic mechanical properties. But corresponding research lacks the dynamic damage characteristics of the polypropylene fiber（fiber of low elastic modulus） and steel fiber（fiber of high elastic modulus） reinforced concrete under medium strain rate（10-6 s-1-10-4 s-1）. In order to study the effect of strain rate on the damage characteristics of fiber reinforced concrete during the full curve damage process, the real time dynamic acoustic emission（AE） technique was applied to monitor the damage process of fiber reinforced concrete at three strain rates. The AE wavelet energy spectrum in ca8 frequency band and average AE peak frequency at three strain rates were analyzed. With the accumulation of damage, the AE wavelet energy spectrum in ca8 frequency band increased first and then decreased, and the average AE peak frequency increased gradually. With the increase of strain rate, the AE wavelet energy spectrum in ca8 frequency band and average AE peak frequency decreased gradually. The polypropylene fiber content has more obvious effect on the Dynamic increase factor（DIF） of the peak stress than the steel fiber content. The theoretical basis was provided for the monitoring of dynamic damage of fiber reinforced concrete based on the AE technique.
The performances of the cement-based materials can be improved by the incorporation of polypropylene fiber, but the damage processes become more complex with different fiber contents at the same time. The acoustic emission（AE） technology can achieve the global monitoring of internal damage in materials. The evolution process of failure mode and damage degree of polypropylene fiber reinforced mortar and concrete were analyzed by measuring the AE energy, RA value, AF value and b value. It was found that the cement matrix cracked on the initial stage, the cracks further developed on the medium stage and the fibers were pulled out on the last stage. The matrix cracked with minor injury cracks, but the fiber broke with serious damage cracks. The cumulative AE energy was proportional to the polypropylene fiber reinforced concrete and mortar＇s ductility. The damage mode and damage degree can be judged by identifying the damage stage obtained by the analysis of the AF value.
