A monolithic microwave integrated circuit （MMIC） power amplifier （PA） is proposed. It adopts a new on-chip bias circuit, which not only avoids the instability of the direct current bias caused by the change in the power supply and temperature, but also compensates deviations caused by the increase in input power. The bias circuit is a current-mirror configuration, and the feedback circuit helps to maintain bias voltage at a constant level. The gain of the feedback circuit is improved by the addition of a non-inverting amplifier within the feedback circuit. A shunt capacitor at the base node of the active bias transistor enhances the linearity of the PA. The chip is fabricated in an InGaP/GaAs heterojunction bipolar transistor （HBT） process. Measured results exhibit a 26. 6-dBm output compression point, 33.6% power-added efficiency （PAE） and - 40.2 dBc adjacent channel power ratio （ACPR） for wide-band code division multiple access （W-CDMA） applications.
In order to make a 10 Gbit/s 2：1 half-rate multiplexer operate without external clocks, a 5 Gbit/s clock recovery （CR） circuit is needed to extract the desired clock from one input data. For the CR circuit, a 3-stage ring voltage-controlled oscillator （VCO） is employed to avoid an unreliable startup of a 2-stage VCO and a low oscillation frequency of a 4-stage VCO. A phase frequency detector （PFD） is used to expand the pull-in range to meet the wide tuning range of a VCO required by process-voltage-temperature （PVT） variation. SMIC 0. 18-μm CMOS technology is adopted and the core area is 170 μm ×270 μm. Measurements show that, under a 1.8 V supply voltage, it consumes only about 90 mW, and has an input sensitivity of less than 25 mV, an output single-ended swing of above 300 mV, a phase noise of - 114 dBc/Hz at 1 MHz offset and a pull-in range of 1 GHz.
