Characterization of electric properties of nanomaterials usually involves fabricating field effect transistors （FET） and deriving materials properties from device performances. However, the quality of electrode contacts in FET devices heavily influences the device performance, which makes it difficult to obtain the intrinsic electric properties of nanomaterials. Dielectric force microscopy （DFM）, a contactless method developed recently, can detect the low-frequency dielectric responses of nanomaterials without electric contact, which avoids the influence of electric contact and can be used to study the intrinsic conductivity of nanomaterials. Here we study the influences of surface adsorbates on the conductivity of ZnO nanowires （NWs） by using FET and DFM methods. The conductivity of ZnO NW is much larger in N2 atmosphere than that in ambient environment as measured by FET device, which is further proven by DFM measurement that the ZnO NW exhibits larger dielectric response in N2 environment, and the influence of electrode contacts on measurement can be ruled out. Based on these results, it can be concluded that the adsorbates on ZnO NW surface highly influence the conductivity of ZnO NW rather than the electrode contact. This work also verifies the capability of DFM in measuring electric properties of nanomaterials.
ZnO nanosheets with thickness of a few nanometers are prepared by vapor transport and condensation method, and their structure and optical properties are well characterized. Field effect transistor （FET） and ultraviolet （UV） sensors are fabricated based on the ZnO nanosheets. Due to the peculiar structure of nanosheet, the FET shows n-type enhanced mode behavior and high electrical performance, and its field-effect mobility and on/off cur- rent ratio can reach 256 cm2/（V.s） and ~10^8, respectively. Moreover, the response of UV sensors can also be remarkably improved to ~3 × 10^8. The results make the ZnO nanosheets be a good material for the applications in nanoelectronic and optoelectronic devices.
Ultraviolet （UV） photodetector constructed by ZnO material has attracted intense research and commercial interest. However, its photoresistivity and photoresonse are still unsatisfied. Herein, we report a novel method to assemble ZnO nanoparticles （NPs） onto the reduced graphite oxide （RGO） sheet by simple hydrothermal process without any surfactant. It is found that the high-quality crystallized ZnO NPs with the average diameter of 5 nm are well dispersed on the RGO surface, and the density of ZnO NPs can be readily controlled by the concentration of the precursor. The photodetector fabricated with this ZnO NPs- RGO hybrid structure demonstrates an excellent photoresponse for the UV irradiation. The results make this hybrid especially suitable as a novel material for the design and fabrication of high performance UV photodector.
We report a simple and green approach to synthesize reduced graphene oxide （RGO） nanosheets at room temperature based on Zn reduction of exfoliated GO. The evolution of GO to RGO has been characterized by X-ray diffraction, UV-Vis absorption spectroscopy and Raman spectroscopy. The results of X-ray photoelectron spectroscopy reveal that the atomic ratio of carbon to oxygen in the RGO can be tuned from 1.67 to 13.7 through controlling the reduction time. Moreover, the conductivity of the RGO is measured to be 26.9±2.2 kS/m, much larger than those previously obtained by chemical reduction through other reducing agents. More importantly, the resistance of the RGO film with 20 nm thickhess can be as low as 2 kΩ/square, while a high transparency over 70% within a broad spectral range from 0.45 pm to 1.50 p.m can be retained. The proposed method is low-cost, eco-friendly and highly-eiffcient, the as-prepared thinner RGO films are useful in a variety of potential application fields such as optoelectronics, photovoltaics and electrochemistry by serving as an ultralight, flexible and transparent electrode material.
